TS screw jacks
ATLANTA TS screw jacks are an economical version of the jacks used in applications where a large number of cycles, high speeds and powers are not required.
Standard screw jacks are a cost-effective alternative especially for medium speed or power lifting applications. Screw jacks as drives with linear displacements are used in all applications where smooth and precise control of lifting, lowering, delivering, pressing, tilting, rotating and similar operations requiring very high positioning precision is needed, i.e. in places where rotary motion is replaced linear motion.
TS – standard screw jacks with a trapezoidal screw.
German contact | English contact |
E-mail: jb@pivexin-tech.com | E-mail: export@pivexin-tech.com |
Tel.: +48 32 438 73 11 | Tel.: +48 32 438 73 01 |
Mob.: +49 (0)1522 5498 597 |
- Trapezoidal screw construction: rotary and non-rotary screw6 sizes: TS2, TS5, TS10, TS25, TS50 and TS100
- Capacity: from 2 to 100kN
- Rotary speed up to 25 mm/s
- Cycle work: up to approx. 30% (depending on load)
- Self-braking – in standard operation.
- Suitable for use with 3-phase AC motors
TS - with a rotating trapezoidal screw
TS – standard screw jacks with a trapezoidal screw.
TS - with a rotating trapezoidal screw
TS - standard screw jacks with a rotating trapezoidal screw
Technical data:
- Movement of the nut causes it to rise or fall
- Trapezoidal thread with different types of nuts
- For large strokes it is possible to use a bearing flange
Accessories:
- Protective bellows
- Swivel bearing nut
- Block pin
- Rotating screws
TS - with a non-rotating screw
TS - standard screw jacks with non-rotating screw
Technical data:
- The screw performs a lifting and falling motion
- The screw goes through the gear
Accessories:
- Mounting flange
- Spade terminal
- Swivel end
- Spherical plain bearing
- Protective bellows
- Protective tube
- Anti-twist element
- Mechanical or inductive limit switches
- Block pin
- Rotating screws